WM_CONTROL (in Spin Button Controls) - Parameters

id (USHORT)

Identity of the spin button component window.

notifycode (USHORT)

Notification code.

SPBN_UPARROW

Tells the application that the Up Arrow was clicked on, or the Up Arrow key was pressed.
SPBN_DOWNARROW
Tells the application that the Down Arrow was clicked on, or the Down Arrow key was pressed.
SPBN_SETFOCUS
Tells the application which spin field was selected.
SPBN_KILLFOCUS
Tells the application when the spin field loses focus.
SPBN_ENDSPIN
Tells the application that the user released the select button or one of the arrow keys while spinning a button.
SPBN_CHANGE
Tells the application that the contents of the spin field changed.

hwnd (HWND)

Window handle.

The interpretation of this handle is dependent upon the following notification codes:

• SPBN_UPARROW, SPBN_DOWNARROW, and SPBN_ENDSPIN.

  The param2 parameter is the handle to the currently selected spin field in a particular master-servant setup. If either the Up or Down Arrow is clicked on and none of a spin button's servants are currently selected, the master will return a handle to itself.

• SPBN_SETFOCUS

  The param2 parameter is the handle of the currently selected spin field.

  This message tells the application which spin field is selected.

• SPBN_KILLFOCUS

  The param2 parameter is NULLHANDLE if the spin field loses focus or no spin field is currently selected.

  This message tells the application when a spin field loses focus.

  Note: Both SPBN_KILLFOCUS and SPBN_SETFOCUS are set independently. You must check this message only when the application does not specify a master-servant relationship.

  
  SPBN_CHANGE

  The param2 parameter is the handle of the spin button in which the spin field text changed.

  ulReserved (ULONG)

  Reserved value, should be 0.

  ---

  [Back: WM_CONTROL (in Spin Button Controls) Return Value - ulReserved]
  [Next: WM_CONTROL (in Spin Button Controls) - Syntax]